45OPERATING THE TRACTOR
BCreep Lever (if equipped)
Shift the creep lever at " " to obtain low speeds with
power shift / range shift lever is selected "L" range.
With the creep lever engaged (ON), the speed range
cannot shift to "M" and "H". (The creep mode does not
operate in the middle-speed and high-speed ranges.)
This shifting requires clutch operation.
C Creep speed should be used only when doing one
of the following jobs:
1. Deep rotary-tilling and harrowing
2. Planting
3. Turf application
C Creep speed can not be used for any of the
followings:
1. Pulling a trailer
2. Front-loader operation
3. Front-blade operation
4. Earth-moving
5. Entering and leaving a field
6. Loading onto and unloading from a truck
To avoid personal injury or death:
A When you leave the tractor, be sure to apply the
parking brake and stop the engine.
A IN APPLYING THE BRAKES:
A The torque of the wheel axle is extremely
high while creep speed is being used. Be
sure to step down on the clutch pedal
completely before applying the brakes, or
the torque will overcome the brakes.
A When starting to operate the tractor, be sure
to release the parking brakes.
Misuse of the brakes may cause damage to
the transmission and is therefore not
acceptable to KUBOTA for coverage under
the warranty.
A Press the clutch pedal completely down and stop the
tractor's motion before shifting the range gear shift
lever.
B4WD / Auto 4WD Switch
To avoid personal injury or death:
A Do not engage the front wheel drive when
traveling at road speed.
A When driving on icy, wet, or loose surfaces,
make sure the tractor is correctly ballasted to
avoid skidding and loss of steering control.
Operate at reduced speed and engage front
wheel drive.
A 4WD model tractor is equipped with 4 wheel
braking and appropriate care should be taken
during hard braking.
A An accident may occur if the tractor is
suddenly braked, such as by heavy towed
loads shifting forward or loss of control.
A The braking characteristics are different
between 2 and 4-wheel drive tractor models. Be
aware of the difference and use carefully.
(N) "NEUTRAL"
(1) Creep Lever (A) "LOW".....Creep ON
(B) "HIGH".............Creep OFF
Press the left half;
The 4WD mode activates.
The 4WD indicator comes on.
To Next Page
Loading...
Need help?
General
