OPERATING THE TRACTOR54
BPerformance Monitor
C Display change
When the RPM dual memory setting is "OFF" and the
Rev-limiter control setting is " ", the instrument panel
LCD changes "Hour meter mode", "Trip meter mode",
"Engine RPM dual memory A", "Engine RPM dual
memory B" each time the display switch is pressed. Select
the appropriate display for the work being performed. If
the "RPM dual memory setting" or "Rev-limiter control
setting" is engaged, the set speed takes priority on the
display.
Each time PTO indicator switch is pressed, the PTO rpm
"shift 1" and "shift 2" are displayed alternately.
C Hour meter mode
The tractor’s total operating hours are displayed.
C Trip meter mode
The total operating hours counted from the previous
resetting is displayed.
Hold down the display switch for 2 seconds or longer to
reset the trip meter to [0. 0].
C PTO rpm indicator
Each time PTO indicator switch is pressed, the PTO rpm
"shift 1" and "shift 2" displayed alternately.
"shift 1" is used to select 540 rpm.
"shift 2" is used to select 1000 rpm.
The figure shown below is an example of the display when
the PTO rpm "shift 2" is displayed.
C Priority display (Engine RPM dual memory A/B,
Rev-limiter control setting)
If the "RPM dual memory setting" or "Rev-limiter control
setting" is engaged, the set speed takes priority on the
display. The figure shown below is an example of the
display when the engine speed has been set for the switch
A side.
(1) PTO indicator switch
(2) Display switch (Hour, Trip, Engine RPM dual memory A/B)
(3) LCD monitor
(1) Switch A
(2) Set engine speed
To Next Page
Loading...
Need help?
General
