2KA
1-4-20
1-4-2 Self-diagnosis
(1) Self-diagnostic function
This unit is equipped with a self-diagnostic function. When a problem is detected, copying is disabled and the problem dis-
played as a code consisting of C followed by a number, indicating the nature of the problem. A message is also displayed
requesting the user to call for service.
After removing the problem, the self-diagnostic function can be reset by turning cover switch off and back on.
List of system errors
When an unexpected error is detected for some reason, a system error will be indicated. (When 0800 error is detected,
JAM05 is indicated.) After a system error is indicated, the error can be cleared by turning the power switch off and then on.
If the error is detected continuously, however, perform the operation shown in Table 1-4-1. If a system error occurs fre-
quently, a fault may have occurred. Check the details of the C call to take proper measures.
Table 1-4-1
System error Contents Operation
0800 Image processing problem
Repetition of JAM05
System error JAM05
1800 Paper feeder communication error (optional
paper feeder)
System error
Service call Partial operation
control
4100 BD initialization problem
System error
Normal service call processing
4200 BD steady-state problem
System error
Normal service call processing
8800 Document finisher communication error
(optional 3000-sheet document finisher)
System error
Service call Partial operation
control
To Next Page
Loading...
Need help?
General
Weight and Dimensions
