10: Service Settings
EDS1100/2100 Device Server User Guide 77
Table 10-11 Syslog
3. Click Submit.
HTTP Settings
Hypertext Transfer Protocol (HTTP) is the transport protocol for communicating hypertext
documents on the Internet. HTTP defines how messages are formatted and transmitted. It also
defines the actions web servers and browsers should take in response to different commands.
HTTP Authentication enables the requirement of usernames and passwords for access to the
EDS1100/2100 device.
This page has three links at the top for viewing statistics and for viewing and changing
configuration and authentication settings.
HTTP Statistics—Viewing statistics such as bytes received and transmitted, bad requests,
authorizations required, etc.
HTTP Configuration—Configuring and viewing the current configuration.
HTTP Authentication—Configuring and viewing the authentication.
HTTP Statistics
To view HTTP statistics:
This page shows various statistics about the HTTP server.
1. Select HTTP on the menu bar and then Statistics at the top of the page. The HTTP Statistics
page appears.
Syslog Settings Description
State Select to enable or disable the syslog.
Host Enter the IP address of the remote server to which system logs are sent for storage.
Local Port Enter the number of the local port on the device from which system logs are sent.
Remote Port Enter the number of the port on the remote server that supports logging services.
The default is 514.
Severity Log Level From the drop-down box, select the minimum level of system message the device
should log. This setting applies to all syslog facilities. The drop-down list is in
descending order of severity (e.g., Emergency is more severe than Alert.)
To Next Page
Loading...
Need help?
General