180
54
Disabling Size Sensing
An administrator may choose to disable auto size sensing on trays. Auto size sensing allows for the
linking of trays. (For more information, see Linking trays.) The values for the Size Sensing menu item
are: Tray x size (where x represents trays 1 through 5), Auto, and Off. Two other menu items,
Executive/B5 and Legal/B4, are for special media sizes. See Sensing special print media sizes for
more information.
To disable auto size sensing:
1 Turn the printer off.
2 Press and hold the Select and Return buttons, and then turn the printer on.
3 Release the buttons when Performing Self Test appears on the display.
When the printer self test completes, Config Menu appears.
4 Press Menu until you see Size Sensing, and then press Select.
Note: Only paper trays that support auto size sensing are displayed on the operator
panel.
5 Press Menu until you see Tray x Sensing, where x represents the tray number of the tray you
select to disable size sensing on, and then press
Select.
Repeat this for the other trays you want to disable size sensing for, if necessary.
6 Press Menu until you see Off, and then press Select.
Saved briefly appears. Config Menu appears again with Size Sensing on the second line.
7 Press Return.
8 Press Menu until you see Exit Config Menu, and then press Select.
Activating Menu Changes briefly appears, followed by Performing Self Test.The
printer returns to the Ready message.
Enabling auto size sensing
To enable auto size sensing, repeat the steps in Disabling Size Sensing.However,instep 6 on
page 180, select Auto instead of Off.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General