Technical Information
13
G 1xxx/G 2xxx
3 Risk of Injury Due to Sharp Edges and Protruding Parts
Danger!
 There may be a risk of injury due to protruding parts.
Protective goggles should be worn.
 There may be a risk of injury due to sharp edges. Protective gloves should
be worn and the edge protection (mat. no. 05057680) should be used.
4 Uninstalling the Dishwasher
Before the machine is removed from its installation niche, the appliance
feet must be screwed in (for positioning, refer to the installation plan).
If this is not done the feet could become damaged.
If the machine is installed on skids, adjusting the feet is not required.
5 Service Work – Casing
Warning!
 If it is necessary to tip the machine when working on its lower areas, it
may only be tilted onto its back.
 The appliance must not be tilted onto its left side as this would cause
brine to run out of the salt container.
 After work has been completed and the machine installed again, a short
program without load should be carried out. This is to remove any salt
residues that might be present and to prevent possible corrosion.
B Modification History
When? Who? What?
2/17/2012 Jessica Naples Tech service bulletins added
8/22/2011 Jessica Naples Fault code F 78 corrected (page 160)
4/26/2011 Jessica Naples
Miele WaterProof System guarantee deleted
(page 79)
6/10/2010 Jessica Naples Updated
3/11/2010 Jessica Naples Updated
2/26/2010 Jessica Naples Compilation for Website
To Next Page
Loading...
Need help?
General
