'15 • HM-T-246
-
-
(3) Carrying in and installation of unit
CAUTION
-
3-1 Carrying in
Please note
3-2 Notabilia for installation of heat pump water heater
(a) Anchor bolt position
(b) Base
(c) Vibration isolation rubber
-
Please note
in such a manner that the entire bottom area of heat
pump water heater's anchoring leg can rest on it.
-
3-3 Notabilia for installation of unvented cylinder
Rectangular hole
each 2 holes in front and rear
≦40°
Unit dimension
≧
100mm
Base
Normally, it is desirable that a
base as specified in the drawing
at the left is provided.
A base wrongly oriented is not
acceptable.
Please use it for renewal installation.
(Please add a base on the center) it is
necessary to prevent sagging.
850
720
8585
594
726
764
Anchor bolt dimension
Anchor bolt position (●mark)
Anchor bolt dimension
Unit
g
Vibration
isolating rubber
85
Rectangular hole
each 2 holes in front and rear
≦40°
20
www.ampair.co.uk | sales@ampair.co.uk
To Next Page
Loading...
Need help?
General
