Operator user‟s manual
26/78
3.7 Photo ID (Optional)
It‟s highly recommended to follow the next steps to make an ID service.
3.7.1 Taking the pictures
Before selecting the PhotoID service at the main screen, the operator should take the pictures
to the customer.
When using a digital camera with an USB cable connected to easyphoto:
If an USB switch is being used between the camera and the easyphoto, this must be
switched to the position where the connection between both devices is disabled, in
order to allow the camera to take pictures.
When an USB switch is not being used, the digital camera USB cable should be
disconnected from the easyphoto.
3.7.2 Selecting the service
Once the “Photo ID” button (in operator mode) is pressed, or the hidden area between language
selection (flags) and prices is pressed, the Photo ID service is started.
The behaviour of the camera when the USB cable is connected or disconnected may vary
depending on the camera brand/model used. Also, the use of an USB switch is not always
necessary. Please ask for more information to your dealer or installer.
To Next Page
Loading...
Need help?
General
