Accessories 7 - 5
Four Slot Ethernet Cradle
This section describes how to set up and use a Four Slot Ethernet cradle with the MC75A. For cradle
communication setup procedures refer to the MC75A Integrator Guide.
The Four Slot Ethernet cradle:
•
Provides 5.4 VDC power for operating the MC75A.
•
Connects the MC75A (up to four) to an Ethernet network.
•
Simultaneously charges up to four MC75A devices.
Charging
Insert the MC75A into a slot to begin charging.
Figure 7-3
MC75A Battery Charging
Battery Charging Indicators
The MC75A’s charge LED shows the status of the battery charging in the MC75A. See Table 1-2 on page 1-7 for
charging status indications.
The 3600 mAh battery fully charges in less than five hours and the 4800 mAh battery fully charges in less than
seven hours.
To Next Page
Loading...
Need help?
General