NETGEAR GS716T User Manual

147
GS716T and GS724T Gigabit Smart Switches
802.1AS Port Settings
Use the 802.1AS Port Settings page to configure and view per-port 802.1AS settings. To
display the 802.1AS Port Settings page click the Switching tab, then click 802.1AS 
Advanced  802.1AS Port Settings.
\
To configure the 802.1AS port settings:
1. To configure 802.1AS settings for one or more ports, click PORTS. To configure
802.1AS settings for one or more LAGs, click LAGs. To configure 802.1AS settings for
both ports and LAGs, click ALL.
2. Select the check box next to the port or LAG to configure. You can select multiple ports or
LAGs to apply the same settings to the selected interfaces. Select the check box in the
heading row to apply the same settings to all interfaces.
3. Enable or disable 802.1AS on the interface.
4. Set the Pdelay threshold. This value specifies the propagation delay threshold on the
interface. The threshold determines whether the port is capable of participating in the
802.1AS protocol. If the propagation delay on the interface is above the threshold you
configure, the interface is not considered capable of participating in the 802.1AS
protocol. The peer delay must be less than the threshold value configured on the interface.
The default value is 2500 nanoseconds. The range is 0–1,000,000,000 ns.
5. Set the value for Allowed Lost Responses. If the interface does not receive valid responses
to PDELAY_REQ messages above the value of the allowed lost responses, a port is
considered to not be exchanging peer delay messages with its neighbor. The default value
is 3. The range is 0–65535.

NETGEAR GS716T Specifications

General

Switch type	Managed
Switch layer	L3
Quality of Service (QoS) support	Yes
Stackable	-
Certification	CE, FCC, VCCI, EN, C-Tick, CCC, CSA, UL/cUL, IEC
Product color	Blue
LED indicators	Activity, Link, Power
SFP module slots quantity	2
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	16
Number of VLANs	256
Networking standards	IEEE 802.1D, IEEE 802.1as, IEEE 802.1s, IEEE 802.1v, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Copper ethernet cabling technology	10BASE-T, 100BASE-TX, 100BASE-T, 1000BASE-T
Noise level	0 dB
Mean time between failures (MTBF)	567680 h
DHCP features	DHCP client
Security algorithms	802.1x RADIUS, HTTPS, SSL/TLS
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	14.4 W
MAC address table	16000 entries
Number of static routes	32
Operating altitude	0 - 3000 m
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	0 - 90 %
Cables included	AC
Supported network protocols	IP

Weight and Dimensions

Depth	204 mm
Width	440 mm
Height	43 mm
Weight	2570 g