ＮＩＳＳＥＩ ＣＯＲＰＯＲＡＴＩＯＮ E6581815
E-5
5
5.3 Setting acceleration/deceleration time
：Automatic acceleration/deceleration
：Acceleration time 1
：Deceleration time 1
Function
1) For acceleration time 1 programs the time that it takes for the inverter output frequency to go
from 0Hz to maximum frequency .
2) For deceleration time 1 programs the time that it takes for the inverter output frequency to go
from maximum frequency to 0Hz.
5.3.1 Automatic acceleration/deceleration
This automatically adjusts acceleration and deceleration time in line with load size.
=
* Adjusts the acceleration/deceleration time automatically within the range of 1/8 to 8 times as long as the
time set with the or , depending on the current rating of the inverter.
=
* Automatically adjusts speed during acceleration only. During deceleration, speed is not adjusted
automatically but reduced at the rate set with .
Output
frequency (Hz)
Deceleration
time
Acceleration
time
When load is small
Time
[sec]
0
Shorten acceleration/deceleration time
Deceleration
time
Acceleration
time
When load is large
Output
frequency (Hz)
Time
[sec]
0
Lengthen acceleration/deceleration time
Set (automatic acceleration/deceleration) to or .
[Parameter setting]
Title Function Adjustment range Default setting
Automatic acceleration/deceleration
0: Disabled (manual setting)
1: Automatic
2: Automatic (only at acceleration)
0
, When automatically setting acceleration/deceleration time, always change the acceleration/deceleration
time so that it conforms to the load. The acceleration/deceleration time changes constantly with load
fluctuations. For inverters that require a fixed acceleration/deceleration time, use the manual settings
(, ).
To Next Page
Loading...
General