Troubleshooting and routine maintenance
133
Replacing periodic
maintenance parts C
The periodic maintenance parts will need to
be replaced regularly to maintain the print
quality. The parts listed below will have to be
replaced after printing approximately 100,000
pages. Please call Océ Authorized Service
Center when the following messages appear
on the LCD.
Packing and shipping
the machine
C
When you transport the machine, use the
packing materials that came with your
machine. If you do not pack the machine
properly, you could void your warranty. The
machine should be adequately insured with
the carrier.
a Turn off the machine’s power switch.
b Unplug the machine from the telephone
wall jack.
c Unplug all the cables and AC power
cord from the machine.
d Push the Scanner Lock Lever down to
lock the scanner. This lever is located on
the left of the scanner glass.
CAUTION
Damage caused to your machine by failure
to lock the scanner before packing and
shipping may void your warranty.
e Open the front cover.
f Take out the drum unit and toner
cartridge assembly. Leave the toner
cartridge installed in the drum unit.
g Put the drum unit and toner cartridge
assembly into the plastic bag and seal
the bag.
h Close the front cover.
i Wrap the machine in the plastic bag and
put it in the original carton with the
original packing material.
LCD message Description
Replace PF
KitMP
Replace paper feeding kit for
MP tray.
Replace PF
Kit1
Replace paper feeding kit for
Upper Tray.
Replace PF
Kit2
Replace paper feeding kit for
Lower Tray.
Replace Fuser Replace fuser unit.
Replace Laser Replace laser unit.
To Next Page
Loading...
Need help?
General
