Omron 3G3JX User Manual

4-56
4-2 Function Mode
4
Functions
•Select the soft lock setting and performing method from the following table.
AT Input Function
This function changes the analog input source by turning on/off the terminal.
•If AT is not allocated to any of the multi-function inputs, this means the AT input = OFF in the above
table.
•Refer to "Analog Input (FV, FI)" (page 4-9).
Reset
This function resets an Inverter trip.
Parameter No. Function name Data Default setting Unit
b031 Soft lock selection
00: Data other than b031 cannot be changed
when the SFT terminal is ON.
01: Data other than b031 and specified frequency
parameters cannot be changed when the SFT
terminal is ON.
02: Data other than b031 cannot be changed.
03: Data other than b031 and the specified
frequency parameter cannot be changed.
10: Data other than parameters changeable
during operation cannot be changed.
01 ⎯
Related functions SFT input
Data Symbol Function name Status Description
16 AT Analog input switching
ON
Depends on the combination with the A005
setting (see the table below).
OFF Same as above.
Related functions C001 to C005
Required settings A001 = 01, A005
A005 set value 00 02 03 04 05
AT terminal input status OFF ON OFF ON OFF ON OFF ON OFF ON
Analog input enabled FV-FC FI-FC FV-FC VR FI-FC VR FV-FC FI-FC
Data Symbol Function name Status Description
18 RS Reset
ON
Shuts off the power if the Inverter is running.
Cleared at trip.
(The same process as when the power is turned on)
OFF Same as above.
Related functions C001 to C005
Required settings C102

Omron 3G3JX Specifications

General

Brand	Omron
Model	3G3JX
Category	Inverter
Language	English