155
Revision History
The manual revision is indicated at the end of the Cat. No. printed at the lower left of back cover of the manual.
The following table outlines the changes made to the manual during each revision. Page numbers refer to the
previous version.
Revision code Date Revised content
1 April 2005 First edition
02 February 2006 Page 9: Precautions added.
Pages 9 and 5-12: Information added on isolating transformers.
Pages 3-7 and 3-8: Information added on I/O data supported by Safety I/O Termi-
nals.
Page 5-9: Changes made to safety output specifications.
Page 6-2: Changes made to indicators and error processing table.
Pages 6-3 to 6-5: Changes made to troubleshooting tables.
Pages 6-6 and 6-7: Changes made to error history table.
03 June 2007 Revised to add information on DST-XD0808SL-1 and corrected mistakes.
04 March 2008 Page xx: Added precaution.
Page xxi: Updated regulations and standards and removed note.
Page 7: Changed definition of “contact operation counters.”
Page 17: Added new material on DST-XD0808SL-1 and parameters that can be set
and deleted previous material.
Page 41: Added crimping tool model.
Page 53: Changed “SAFE” and “NON-SAFE” designations in table.
Pages 55 to 58: Changed description of default values.
Pages 77, 80, 84, and 89: Changed “DRAIN” to “Shield” in circuit diagrams.
Page 83: Removed specification for the rated load for an inductive load.
Page 94: Added information for the DST-XD0808SL-1.
Pages 97 to 99: Changed error names and responses.
05 September 2008 Page xxi: Changed TUV Rheinland standards.
Pages 6 to 8: Changed references for online monitoring and maintenance functions.
Page 20: Added sections 1-6 and 1-7.
Page 30: Added new section 3-1(but new section 3-1-9 was previously 3-1-8).
Page 37: Changed descriptions of input data.
Page 38: Changed descriptions of output data, moved note from previous page, and
added note.
Page 57: Changed first note in section 4-2-4.
Cat. No. Z904-E1-06
Revision code
To Next Page
Loading...
Need help?
General
