20 LD Cart Transporter User's Manual 14766-000 Rev H
1.4 How Can I Get Help?
Including a DebugInfo File
If the platform has been set up on a wireless network, skip to SetNetGo Access on page 21.
Network Setup
If the AMR has not been set up on a wireless network, a local area network will have to be set
up on a separate PC, and configured to talk to the AMR over a TCP/IP port. The IP address
should be set to: 1.2.3.5. The Subnet Mask should be 255.255.255.0.
(Windows 7)Start >Control Panel >(Network and Internet >)Network and Sharing Center
>Change adapter settings
(Windows 10)Start >Settings >Network and Internet >Change adapter options
Right-click on the LAN Connection, and click on Properties.
From the Properties dialog, scroll to and double-click the Internet Protocol (TCP/IP or
TCP/IPv4) option. In Internet Protocol Properties, click both “Use the following…” radio but-
tons to enable them, and then type in the IP and netmask values.
Connect the network port of your computer to the platform's Maintenance port. See the figure
Location of Parts in the Payload Bay on page 146.
To Next Page
Loading...
Need help?
General
