Chapter 4: Configuration
Setting Up Wireless Ethernet
The SetNetGo OS is used to configure the platform wireless Ethernet, among other things. Refer
to the FLOW Core User's Guide for details.
NOTE: Although an LD Platform Cart Transporter is capable of working
without wireless Ethernet if there are no other AMRs that it needs to know about
(and to avoid), that is the exception. In most cases, wireless Ethernet will be
needed.
NOTE: For all of the following settings, work with your IT group to verify the
correct IP, radio, and security settings.
The following applies to the wireless Ethernet supported by the platform.
The SetNetGo OS is used to configure the wireless Ethernet, among other things. Refer to the
FLOW Core User's Guide for details.
Access the SetNetGo OS through the MobilePlanner software:
MobilePlanner >î ±SetNetGo >î ±Network
NOTE: It is also possible to connect directly to the SetNetGo OSî ±on a platform
through a web browser. The main intent of this is to allow your IT support to set
up the network for you, without using MobilePlanner, which requires a license.
IP Address, Netmask, Gateway, DNS1
Choose Static (DHCP is not recommended), and fill in the IP address, netmask, gateway, and
DNS1, as supplied by your network administrator.
NOTE: The following settings have to be provided by your IT department.
Radio Settings
l
SSID (e.g. AGV)
Fill in the appropriate wireless SSID for your wireless network.
The SSID is case sensitive.
l
Mode
Managed/STA, Ad-Hoc, or Master/AP
l
Radio Mode
Auto, 802.11a, 802.11b, 802.11g
l
Channel Set
l
Wireless Watchdog IP Address
l
Wireless Watchdog Max Count
0 disables this.
14766-000 Rev H LD Cart Transporter User's Manual 65
To Next Page
Loading...
Need help?
General
