177
10. Using Menu Functions
Applicable modes:
You can adjust the brightness of bright and dark portions on an image while checking the
brightness on the screen.
1 Rotate the control ring to adjust the brightness of
bright areas and rotate the control dial to adjust the
brightness of dark areas.
A Bright portion
B Dark portion
• Adjustments can also be made by dragging the graph.
• To register a preferred setting, press 3, and select the
destination where the custom setting will be registered to
([Custom1] ( )/[Custom2] ( )/[Custom3] ( )).
2 Press [MENU/SET].
[Highlight Shadow]
> [Rec]/ [Motion Picture] > [Highlight Shadow]
(Standard) A state with no adjustments is set.
(Raise the contrast) Bright areas are brightened, and dark areas are darkened.
(Lower the contrast) Bright areas are darkened, and dark areas are brightened.
(Brighten dark areas) Dark areas are brightened.
// (Custom) Registered custom settings can be applied.
• The screen display can be switched by pressing [DISP.] on the brightness adjustment screen.
• Turning off this unit will return the setting adjusted with / / / back to the default
setting.
Not available in these cases:
• [Highlight Shadow] cannot be set in the following cases:
– When using [Panorama Shot]
– When using [Filter Settings]
MENU
To Next Page
Loading...
Need help?
General
