12. Connecting to other equipment
280
Printing the Pictures
You can directly connect the camera to a PictBridge-supported printer for printing.
Preparations:
• Perform the print quality and other settings at the printer before printing the pictures.
• Turn on the camera and the printer.
1
Connect the printer and camera with the USB connection cable
(supplied).
• Check the direction of the terminals and plug in/out straight holding onto the plug.
(It may result in malfunction by the deforming of the terminal if it is plugged in obliquely
or in wrong direction.)
Do not connect devices to incorrect terminals. Doing so may cause malfunction.
• Do not use any other USB connection cables except the supplied one.
• A message about charging may be displayed. Wait until the display disappears.
A [USB/CHARGE] socket
B USB connection cable (supplied)
• Do not disconnect the USB connection cable while [å] (Cable disconnect prohibit icon)
is displayed.
(May not be displayed depending on the type of printer used.)
2
Press 3/4 to select [PictBridge(PTP)], and then press [MENU/SET].
3
Press 2/1 to select the picture and then press [MENU/SET].
4
Press 3/4 to select [Print start] and then press [MENU/SET].
To Next Page
Loading...
Need help?
General
