11. Using the Wi-Fi/Bluetooth function
228
Wi-Fi function/Bluetooth function
∫ Before Use
• Set the clock. (P32)
• To use the Wi-Fi function on this unit, a wireless access point or a destination device equipped
with the wireless LAN function is required.
∫ About the WIRELESS connection lamp
• In [Wireless Connection Lamp] in the [Setup] menu, you can set the
lamp so that it will not light/flash. (P202)
∫ About the [Wi-Fi] button
In these operating instructions, a function button to which [Wi-Fi] is assigned is referred to
as the [Wi-Fi] button.
(By default, [Wi-Fi] is assigned to [Fn6] when the camera is in Recording Mode, while it is
assigned to [Fn1] when the camera is in Playback Mode.)
• For information about the function button, refer to P50.
Steps for pressing [Wi-Fi] (in Recording Mode)
1 Touch [ ].
2 Touch [ ].
Lit blue
When the Wi-Fi/Bluetooth function is turned on or
connected
Blinking blue When sending image data by operating the camera
Fn10
Fn10
Fn6
Fn6
OFF
OFF
Fn8
Fn8
Fn7
Fn7
Fn9
Fn9
OFF
OFF
To Next Page
Loading...
Need help?
General
