195
10. Using Menu Functions
Indicates parts that may become white saturated through overexposure in a zebra pattern.
Select [SET] to set the brightness to be processed as a zebra pattern.
• You can select a brightness value between [50%] and [105%]. In [Zebra 2], you can select
[OFF]. If you select [100%] or [105%], only the areas that are already white saturated are
displayed in a zebra pattern. The smaller the value is, the wider the brightness range to be
processed as a zebra pattern will be.
Display the exposure metre.
When you set the focus manually, an MF guide that allows
you to check the direction to achieve focus is displayed.
A Indicator for ¶ (infinity)
[Zebra Pattern]
[ZEBRA1] [ZEBRA2]
• If there are any white saturated areas, we recommend compensating the exposure towards
negative referring to the histogram and then taking the picture.
• Displayed zebra patterns will not be recorded.
• If you assign [Zebra Pattern] to [Fn Button Set] in the [Custom] ([Operation]) menu, each time
you press the function button to which the setting is assigned, the zebra pattern toggles as
follows:
[Zebra 1]
> [Zebra 2] > [OFF].
If you set [Zebra 2] to [OFF], the pattern toggles in the order of [Zebra 1]
> [OFF]
[Expo.Meter]
• Set to [ON] to display the Exposure metre when performing
Programme Shift, setting aperture, and setting shutter speed.
• Unsuitable areas of the range are displayed in red.
• When the Exposure metre is not displayed, switch the display
information for screen by pressing [DISP.].
• If no operations are performed for approximately 4 seconds, the Exposure metre disappears.
[MF Guide]
2
00
0
60
2.8
98
98
SS
SS
F
250 125 60 30 15
2.82.0 4.0 5.6
To Next Page
Loading...
Need help?
General
