6
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
6.15
21.Connect the CPS (N), vehicle speed sensor (P), ECT
sensor (Q) and transmission switch (R).
22.Install the vent line (S) to the transmission fitting.
23.Install two new plastic tie straps to retain the harness
to the transmission.
24.Note the location marks on the shift cable made
during transmission removal and install the shift cable
on the bracket (T). While holding the upper shift cable
jam nut (U), tighten the lower jam nut (V) to secure
the shift cable in the bracket.
25.Install the PVT inner clutch cover, drive clutch, driven
clutch, drive belt and outer clutch cover. Refer to PVT
Assemblypage procedure.
26.Install both rear drive shafts. Refer to “Rear Drive
Shaft Installation”page procedure.
27.Install the front propshaft. Refer to “Front Propshaft
Removal / Installation”page procedure.
28.Safely lower the vehicle.
29.Install the rear cargo box assembly. Refer to “Cargo
Box Installation”page procedure.
NOTICE
Be sure to connect the tail light harness upon
installation.
30.Connect the (-) negative battery cable.
31.If the transmission lubricant was drained for service,
fill the transmission with the specified amount of
Polaris AGL. Refer to “Transmission
Lubrication”page .
FLUID CAPACITY
Recommended Transmission Lubricant: AGL
(PN: 2878068) (Quart)
Capacity: 41 oz. (1200 ml)
TRANSMISSION
To Next Page
Loading...
Need help?
General
