2.56
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
3. Measure the distance between the marks and record
the measurement. Call this measurement
w
.
4. Rotate the tires 180° by moving the vehicle forward.
Position chalk marks facing rearward, even with the
hub/axle center line.
5. Measure the distance between the marks and record.
Call this measurement
e
. Subtract measurement
e
from measurement
w
; this is the vehicle toe.
MEASUREMENT
Wheel Toe-Out:
0.0 in (0.0 mm) +/- 0.25 in (6.35 mm)
WHEEL TOE ADJUSTMENT
PRELIMINARY INFO
NOTICE
If toe alignment is incorrect, measure the distance
between vehicle center and each wheel. This will
indicate which tie rod needs adjusting.
IMPORTANT
Ensure the steering wheel is straight before
determining which tie rod needs adjustment.
Measurements should be equal.
CAUTION
If the rod end is positioned incorrectly it will not pivot,
and may break.
ADJUSTMENT
1. Hold tie rod end to keep it from rotating.
2. Loosen jam nuts at both end of the tie rod.
3. Adjust the tie rod as needed to achieve the proper toe
setting.
IMPORTANT
When tightening the tie rod end jam nuts, the rod ends
must be held parallel to prevent rod end damage and
premature wear. Damage may not be immediately
apparent if done incorrectly.
4. After alignment is complete, torque jam nuts to
specification.
TORQUE
Tie Rod Jam Nut:
13 ft-lbs (18 Nm)
MAINTENANCE
To Next Page
Loading...
Need help?
General
