1.42
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
4. Once the installation is complete, launch the Digital
Wrench® software and verify the information in the
lower, right-hand corner matches the new Base
Version you just installed.
DIGITAL WRENCH® COMMUNICATION
ERRORS
If you experience problems connecting to a vehicle, or
any other Digital Wrench® software-related problem, visit
the Digital Wrench® home page (www.polaris.diagsys.
com) and locate the following information under
Knowledge Base:
• Errors and Troubleshooting
• Frequently Asked Questions (FAQs)
• Procedures and Solutions
DIGITAL WRENCH® - DIAGNOSTIC
CONNECTOR
The diagnostic connector is located under the storage
tray below the middle seat and is connected to a sealed
plug. To access the diagnostic connector lift up the
passenger seat and remove the storage tray.
Follow these steps to connect the diagnostic interface
cable to the vehicle to allow Digital Wrench® use:
1. Assemble the MultiLink Module and attach the PC
Interface Cable to your laptop.
2. Remove the protective cap from the Digital Wrench®
connector.
3. Connect the Vehicle Interface Cable to the Digital
Wrench® diagnostic connector.
4. Turn the ignition key to the ‘ON’ position, select the
appropriate vehicle and wait for the status to display
‘Connected’ in the lower left corner of the screen.
5. Once connected, proceed with using Digital
Wrench®.
DIGITAL WRENCH® SERIAL NUMBER
LOCATION
To locate the Digital Wrench® serial number, do the
following:
1. Launch the Digital Wrench® software.
2. On the Digital Wrench® main screen, select the
‘Configure the Diagnostic System Software’ menu
icon.
3. Locate the serial number on the right side of the
System Configuration screen.
GENERAL INFORMATION
To Next Page
Loading...
Need help?
General
