Qlogic QConvergeConsole CLI 2400 Series User Manual

6–iSCSI Noninteractive Commands
-dp
SN0054667-00 C 6-7
 FW attribute
 FW version 2
 FW attribute 2
-dp
Use the -dp command to preinstall an adapter driver specified from a .zip
or .inf file. This operation may be performed without an adapter installed in the
system.
You can specify the following actions:
 p — Preinstall driver package (default)
 i — Install driver package
 u — Uninstall driver package
 g — Get driver package path
You may also specify the following flags:
 DRIVER_PACKAGE_FORCE
 DRIVER_PACKAGE_LEGACY_MODE
 DRIVER_PACKAGE_ONLY_IF_DEVICE_PRESENT
 DRIVER_PACKAGE_REPAIR
 DRIVER_PACKAGE_SILENT
You may need to reboot the system following this command. For details about the
success or failure of the driver update operation, view the trace log file.
-dr
(Display Default Router List [IPv6 only])
The IPv6 default router list includes both the active default router and a short list
of other routers that advertised themselves as capable of acting as a default
router. The active default router always appears first in the list.
To view the default router list, issue the -dr command as follows:
-dr <hba_port_inst>
-dspchap
(Display a CHAP Table)
To view the CHAP table, issue the -dspchap command as follows:
-dspchap <hba_port_inst>
-dtdsp
(Display Discovered Targets)
To view the discovered targets that are not persistent, issue the -dtdsp
command as follows:
-dtdsp <hba_port_inst>

Qlogic QConvergeConsole CLI 2400 Series Specifications

General

Brand	Qlogic
Model	QConvergeConsole CLI 2400 Series
Category	Software
Language	English