Qlogic QConvergeConsole CLI 2400 Series User Manual

5–Fibre Channel Noninteractive Commands
Host Configuration (Command Line Option -z)
5-2 SN0054667-00 C
 List of adapters: adapter model, port number, WWPN, serial number (SN),
adapter number (adapter 0–n), and status (online or offline)
 Total number of QLogic Fibre Channel adapters detected
Host Configuration
(Command Line Option -z)
The command line option -z provides a summary for the selected adapter in a
single command. The command format is:
# qaucli -pr fc -z
QConvergeConsole CLI shows the information in “Host Information (Command
Line Option -g)” on page 5-1, as well as the following additional information:
 Adapter general information
 Adapter vital product data (VPD)
 Adapter parameter settings
 Driver settings information:
 Group: persistent
 Group: binding
 Device/LUN Information
 Selective LUNs Information
 Boot device settings
To show the information for a single adapter, issue the following command:
# qaucli -pr fc -z (<hba instance> | <hba wwpn>)
Where:
To show the information for all adapters, issue the following command:
# qaucli -pr fc -z all
NOTE:
The failover and SAN device management APIs are QLogic-specific libraries
required for QConvergeConsole CLI. The versions of these libraries are
useful for debugging purposes.
hba instance
= Adapter number (use -g command to find)
hba wwpn
= World wide port name of the adapter

Qlogic QConvergeConsole CLI 2400 Series Specifications

General

Brand	Qlogic
Model	QConvergeConsole CLI 2400 Series
Category	Software
Language	English