11–NIC Partitioning (NPAR) Interactive Commands
Setting Up NIC Partitions
SN0054667-00 C 11-5
f. Specify whether you want your bandwidth settings to persist across
reboots (Figure 11-6).
Figure 11-6. Setting Bandwidth Changes to Persist
7. Return to the NIC Partitioning <NPAR> Configuration Selection screen.
8. Change the personalities of each function to meet your system
requirements. For example:
a. Select option 2: Change PCI Function Personality.
b. Select the port number, 1 or 2.
c. Select the function number. The command line displays a list of
options with choices that apply to the selected function number. This
mode prevents you from assigning a function type that does not apply
to a given function number.
d. Set the personality type by selecting the option number that identifies
the desired function type. Depending on the function number and
current state, this could be Disabled, NIC, FCoE, or iSCSI.
NOTE:
For a list of NPAR configuration options, see “NPAR Setup” on page A-8.
To Next Page
Loading...
Need help?
General
