Qlogic QConvergeConsole CLI 2400 Series User Manual

5–Fibre Channel Noninteractive Commands
-n (Set Selected HBA Parameter)
5-26 SN0054667-00 C
-n
(Set Selected HBA Parameter)
To set a specific parameter on a specific adapter, issue the following command:
# qaucli -pr fc -n (<hba instance> | <hba wwpn>) { (<param name> |
<param alias>) <param value>}
To restore the default BIOS (4G adapters only), issue the following command:
# qaucli -pr fc -n (<hba instance> | <hba wwpn>) default
Where:
The pairs <param name> <param value> and <param alias> <param value> can
be repeated to set multiple parameters with a single command.
Table 5-9 lists the adapter parameter names and aliases.
.
hba instance = Adapter number (use -g command to find)
hba wwpn = World wide port name of the adapter
param name = Name of the parameters
param alias = Alias of the parameters
param value = New value of the parameters
Table 5-9. Adapter Parameters
Description Name Alias Value
Connection options ConnectionOption CO
See table note
a
Data rate DataRate DR
See table note
b
Enable BIOS
EnableBIOS
c
EB 1=Enable, 0=Disable
Enable extended logging
EnableExtendedLogging
d
EL 1=Enable, 0=Disable
Enable Fibre Channel tape EnableFCTape EF 1=Enable, 0=Disable
Enable hard loop ID EnableHardLoopID HL 1=Enable, 0=Disable
Enable LIP full login EnableLIPFullLogin FL 1=Enable, 0=Disable
Enable LIP reset EnableLipReset LP 1=Enable, 0=Disable
Enable target reset EnableTargetReset TR 1=Enable, 0=Disable
Execution throttle ExecutionThrottle ET 1–65535
Frame size FrameSize FR 512, 1024, 2048
Hard loop ID HardLoopID HD 0–125
Interrupt delay timer InterruptDelayTimer ID 0–255

Qlogic QConvergeConsole CLI 2400 Series Specifications

General

Brand	Qlogic
Model	QConvergeConsole CLI 2400 Series
Category	Software
Language	English