Rewinder
96 QL-800 User Guide
7 Feed the media under the rewinder dancer arm [5] and up around the empty label
core. The inside edge of the media should be aligned squarely with the inner flange
[1].
If the media is not squarely aligned with the inner flange, adjust the position of the
rewinder as needed.
• Loosen the thumb screws that fasten the rewinder to the bracket. Slide the
rewinder left/right as allowed by the adjustment slots until the media is squarely
aligned with the inner flange. Then tighten the thumb screws.
8 Fasten the end of the media to the core with tape. Ensure the printed side faces
out.
9 Reinstall the outer flange [2] and then turn the mandrel adjustment knob [4]
clockwise to tighten the mandrel.
10 Install the removable roll support arm [7]. Then tighten the thumb screw [6] to lock
it into position.
11 Turn the power switch [3] on the rewinder to the on position.
When the dancer arm is in a lowered position, the rewinder mandrel will rewind
media as needed. Do not turn the mandrel by hand to rewind the media. The media
rewind path is illustrated below.
12 Resume the print job on the QL-800 printer. The rewinder will rewind media
automatically as needed. The rewinder will stop when the printer stops advancing
media or when the printer is out of media.
To Next Page
Loading...
Need help?
General