QL-800 User Guide 93
7
Rewinder
Before Installing the Rewinder
Before installing the rewinder, observe the following precautions.
• No rewinder feet should float. The rewinder must be held level constantly.
• The rewinder must be installed on the same plane as the printer.
• The rewinder weighs 25 pounds (11.3 kilograms). When placing the rewinder on a
desk, table, or other similar surface, it must be sturdy and stable enough to support
the weight of the printer and the rewinder.
• Do not turn the rewinder mandrel by hand to rewind the media. Turning the mandrel
by hand can result in rewinder damage.
Installing the Rewinder
Use the following instructions to install the rewinder. Refer to the following illustration
during this process.
1 Ensure the power switch [6] on the rewinder is in the off position.
2 Power off the printer. On the rear of the printer, turn the power inlet switch off.
To Next Page
Loading...
Need help?
General