2. Remove the originals that were being copied.
3. Place the originals you want to copy.
4. Press the [Start] key.
The machine starts making copies.
5. When copying is complete, remove the originals and copies.
6. Press the [Interrupt] key again.
The interrupt key indicator goes off.
7. Replace the originals that you were copying, and then press the [Start] key.
Following the instructions on the display.
• The previous copy job settings are restored. Simply press the [Start] key to continue copying from
where it left off.
Auto Start
If you make settings and scan originals while the machine is busy, your copies will be made once the
machine is ready.
1. Make your settings while "Select copy mode, then press the Start key." and "Scanning
originals can be started." are displayed alternately.
2. Place the original.
3. Press the [Start] key.
The machine scans the original.
Copying starts automatically once the machine is ready.
Job Preset
You can make settings for the next copy job during copying.
Basic Procedure
41
To Next Page
Loading...
Need help?
General
