Configuring User Authentication
There are five types of user authentication methods: User Code authentication, Basic authentication,
Windows authentication, LDAP authentication, and Integration Server authentication. To use user
authentication, select an authentication method on the control panel, and then make the required
settings for the authentication. The settings depend on the authentication method. Specify administrator
authentication, and then specify user authentication.
• If user authentication is not possible because of a problem with the hard disk or network, you can
use the machine by accessing it using administrator authentication and disabling user
authentication. Do this if, for instance, you need to use the machine urgently.
• You cannot use more than one authentication method at the same time.
User authentication configuration flow
Configuration procedure Details
Configuring administrator authentication page 17 "Specifying Administrator Privileges"
page 19 "Registering and Changing
Administrators"
Configuring user authentication Specify user authentication.
Five types of user authentication are available:
• page 34 "User Code Authentication"
• page 37 "Basic Authentication"
• page 43 "Windows Authentication"
• page 53 "LDAP Authentication"
• page 58 "Integration Server
Authentication"
User authentication methods
Type Details
User Code authentication Authentication is performed using eight-digit user codes.
Authentication is applied to each user code, not to each user.
It is necessary to register the user code in the machine's address
book in advance.
Configuring User Authentication
31
To Next Page
Loading...
Need help?
General
