Category Item Setting
Security User
Lockout Policy
Lockout Release Timer Set to [Active] or [Inactive].
When setting to [Active], set the Lockout release
timer to 60 minutes or more.
For details, see page 69 "User Lockout Function".
Security User
Lockout Policy
Lock Out User for When setting "Lockout Release Timer" to [Active],
set the Lockout release timer to 60 minutes or
more.
For details, see page 69 "User Lockout Function".
Network
SNMPv3
SNMPv3 Function Inactive
To use SNMPv3 functions, set "SNMPv3
Function" to [Active], and set "Permit SNMPv3
Communication" to [Encryption Only]. Because
SNMPv3 enforces authentication for each
packet, Login log will be disabled as long as
SNMPv3 is active.
Security
Network Security
FTP Inactive
Before specifying this setting, set "Network
Security Level" to [Level 2] on the control panel.
Security S/MIME "Encryption Algorithm": AES-128 bit, AES-256
bit, or 3DES-168 bit
You must register the user certificate in order to
use S/MIME.
Address Book
Detail Input Add
User/Change
Email
User Certificate You must register the user certificate in order to
use S/MIME.
• The administrator must indicate which strength level is to be specified for the encryption algorithm.
• For details about specifying an encryption algorithm and registering a user certificate, see
page 141 "Configuring S/MIME".
Additional Information for Enhanced Security
271
To Next Page
Loading...
Need help?
General
