• Refer to the Service Tables for the range of allowed settings.
5. Do this procedure to enter a setting:
• Press to toggle between plus and minus and use the keypad to enter the appropriate
number. The number you enter writes over the previous setting.
• Press to enter the setting. (The value is not registered if you enter a number that is out of
range.)
• Press "Yes" when you are prompted to complete the selection.
6. If you need to perform a test print, press Copy Window to open the copy window and select the
settings for the test print. Press Start and then press SP Mode (highlighted) in the copy window to
return to the SP mode display.
7. Press Exit two times to return to the copy window when you are finished.
Exiting Service Mode
Press the Exit key on the touch-panel.
Service Mode Lock/Unlock
At locations where the machine contains sensitive data, the customer engineer cannot operate the
machine until the Administrator turns the service mode lock off. This function makes sure that work on the
machine is always done with the permission of the Administrator.
1. If you cannot go into the SP mode, ask the Administrator to log in with the User Tool and then set
"Service Mode Lock" to OFF after he or she logs in:
User Tools > System Settings > Administrator Tools > Service Mode Lock > OFF
• This unlocks the machine and lets you get access to all the SP codes.
5. System Maintenance
284
To Next Page
Loading...
Need help?
General