NVRAM Data Upload/Download
Uploading Content of NVRAM to an SD card
Do the following procedure to upload SP code settings from NVRAM to an SD card.
• This data should always be uploaded to an SD card before the NVRAM is replaced.
• Make sure that the write protection of an SD card is unlocked
1. Do SP5-990-001 (SMC Print) before you switch the machine off. You will need a record of the
NVRAM settings if the upload fails.
2.
Switch the copier main power switch off.
3. Remove the controller cover [A] ( x 1).
4. Insert the SD card [A] into SD slot 2. Then switch the copier on.
5. Execute SP5-824-001 (NVRAM Data Upload) and then press the “Execute” key.
NVRAM Data Upload/Download
301
To Next Page
Loading...
Need help?
General