Ricoh OR-C1 User Manual

No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
402 D
Transfer roller leak error 2
A transfer roller current leak signal is detected. The current feedback signal for the
transfer roller is not detected within the correct time.
• Transfer roller set incorrectly or damaged
•
High voltage supply board set incorrectly or defective
1.
Check the high voltage supply board is set correctly.
2. Check the harness of the high voltage supply board.
3.
Replace the high voltage supply board.
4. Check the transfer roller is set correctly.
5. Replace the transfer roller.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
411 D
Separation bias leak error
A separation bias leak signal was detected.
• High voltage supply board defective
• Discharge plate defective
1.
Check the harness of the high voltage supply board.
2. Replace the high voltage supply board.
3.
Replace the discharge plate.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
490 D
Toner supply motor leak error r
More than 1 ampere supplied to the toner supply motor for longer than 200 ms.
• Toner supply motor defective
1. Replace the toner transport motor.
Service Call Conditions
57
3

Ricoh OR-C1 Specifications

General

Brand	Ricoh
Model	OR-C1
Category	Printer
Language	English