11Publication 2711C-QS001F-EN-P - November 2010 11
Preface
About This Publication
Use this manual to create a sample application to run in a PanelView
Component HMI terminal. You will use the design environment of the
PanelView Explorer software to create the application.
This manual describes the necessary tasks to connect your computer to a
PanelView Component terminal, launch the PanelView Explorer software in
your web browser, create a sample application in the design environment,
validate the application, and run the application while connected to a
Micrologix 1100 controller.
The beginning of each chapter contains the following information.
Read these sections carefully before beginning work in each chapter.
• Before You Begin - This section lists the steps that must be
completed and decisions that must be made before starting that chapter.
The chapters in this quick start do not have to be completed in the order
in which they appear, but this section defines the minimum amount of
preparation required before completing the current chapter.
• What You Need - This section lists the tools that are required to
complete the steps in the current chapter. This includes, but is not
limited to, hardware and software.
• Follow These Steps - This illustrates the steps in the current chapter
and identifies which steps are required to complete the examples.
Audience
This quick start was created to assist application designers on how to create
applications to run in a PanelView Component HMI terminal. The designer
may or may not be familiar with Rockwell Automation HMI software. An
understanding of Rockwell Automation controllers and communication
protocols is helpful but not necessary.
To Next Page
Loading...
Need help?
General
