Section 2J: Using Sprint PCS Ready Link 189
Receiving a Sprint PCS Ready Link Call
To receive a Sprint PCS Ready Link call:
1. Make sure your phone’s Sprint PCS Ready Link mode is
enabled. (See “Setting Sprint PCS Ready Link Mode” on
page 181.)
2. When you receive a Sprint PCS Ready Link call from a
contact, “R-Link Call,” the contact’s name, and the
Sprint PCS Ready Link number are displayed. (You do not
need to take any action to answer the call.)
n
When you receive a group call, “Group Call,”the
group member’s name, and the Sprint PCS Ready
Link number are displayed.
3. If the person placing the call has kept the floor (held the
Ready Link/Recorder button), you will see the contact’s
name and Sprint PCS Ready Link number along with “has
floor,” and you will hear the caller speaking.
4. When the caller finishes speaking and releases , you
will see “Floor is open” on the display screen. Press and
hold to take the floor and reply to the caller. (You
will see “You have floor”and hear a tone confirming that
you may speak.)
5. When the conversation is finished, press .
Note:
You can change the volume and the speaker setting while a
Sprint PCS Ready Link call is activated. Volume: Adjust the
voice volume by using the Side Volume key or by pressing the
navigation key up or down (except when you are pressing and
holding the Ready Link button). Speaker: Switch the speaker
on or off by pressing the Speaker button.
Tip:
You can also receive a Sprint PCS Ready Link call with the
phone closed. Press and hold the Ready Link button to take
the floor when the floor is open.
Sprint PCS Ready Link
To Next Page
Loading...
Need help?
General
