Video function
185
Step by Step
Installing a USB camera
You can connect most of the currently commercially
available USB cameras.
Connecting a USB camera
Plug the USB connector of the camera into the USB
port on the bottom of your OpenStage 60/80 (see
 page 17).
If you see the following message, the USB camera has
been detected and can be used.
Activating and deactivating the video
function
z
You can also configure this setting via the WEB
Surface  page 271.
v Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec. j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select the option shown.
Select and confirm the option shown in the context
menu to activate.
or
Select and confirm the option shown in the context
menu to deactivate.
Select and confirm the option shown.
New USB device detected
video.camera USB2.0 Camera
User
Configuration
Video call
Video on
Yes
No
Save & exit
To Next Page
Loading...
Need help?
General