Getting to know your OpenStage phone
25
Programmable sensor keys
Your OpenStage 80 SIP has nine (OpenStage 60 SIP: eight) illuminated
sensor keys. You can assign functions or numbers to them.
To open the programming menu, press and hold down the relevant sensor
key  page 94.
To activate the programmed function, briefly press the relevant key
 page 98.
Depending on how they are programmed, you can use the sensor keys as:
• Function keys  page 93
• Repdial keys  page 93
• Direct station selection keys  page 135
Touch the key briefly to activate the programmed function or dial the stored
number  page 98.
If you hold the key pressed, you are prompted as to whether to start pro-
gramming this function key.
A label indicating the key’s function is displayed to the left of the key; it can-
not be changed. You can change the labels for repdial keys according to
your requirements.
The status of a function is shown by the LED on the corresponding sensor
key.
Meaning of LED displays on function keys
Increase the number of programmable sensor keys by connecting a
key module  page 19.
If the prompt is not displayed or a programmed function is not exe-
cuted, then you can only launch key programming via the user menu
(ask your administrator about the current setting).
Line and DDS keys can only be programmed by administrator via
the service menu.
LED Meaning of function key
S
Off The function is deactivated.
T
Flashing
1
[1] In this manual, flashing sensor keys are identified by this icon, regardless of the flashing in-
terval. The flashing interval represents different statuses, which are described in detail in
the corresponding sections of the manual.
Indicates the function status.
R
On The function is activated.
To Next Page
Loading...
Need help?
General