Diagnostics and upkeep
7.3 SINAUT diagnostics and service tool
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
255
●
Time synchronization
tab:
Status of the time-of-day synchronization on the interfaces of the TIM
●
Time
tab:
Information on the system clock of the TIM
●
Filesystem
tab:
Displays all the files in the flash file system or on the RAM disk of the TIM
1. Select a subscriber in the
SINAUT subscriber list
of the open project or in
Accessible
Nodes
.
2. Open the dialog by selecting the
SINAUT / TIM Diagnostics
menu.
3. Select the individual tabs with the mouse.
4. To display the interface-specific diagnostic data in the
Communication
and
Time
Synchronization
tabs, select the name of an interface. The information on the relevant
interface is displayed in the fields in the lower part of the two tabs.
– In the
Communication
tab: Select an interface in the
Communication drivers
list box.
– In the
Time Synchronization
tab: Select an interface in the
Communication interfaces
for time synchronization
list box
The
Memory
tab displays current diagnostic data on the memory configuration on the TIM:
● In the
Memory configuration
field:
– Static flash EPROM
– Dynamic flash EPROM
– RAM
– Available RAM: Size of the free storage space available to the drivers on the TIM for
dynamic data.
– Memory overflow: If the free RAM is no longer adequate, a checkmark appears in the
Memory overflow
check box.
– Message memory: Size of the memory for data messages that can be stored
– Size of a memory block that is reserved for a DNP3 event.
– Number of stored events
● In the
Disc configuration
field:
– Storage space, used and free storage capacity of the flash or RAM disk.
The tab displays the current diagnostic data on the size and utilization of the buffer areas for
messages on the selected TIM module.
To Next Page
Loading...
Need help?
General
