Dimension drawings
5.4 CAD data, dimension drawings, and circuit-diagram macros
SIMOTION D4x5
72 Manual, 02/2012
5.4 CAD data, dimension drawings, and circuit-diagram macros
Dimension drawings and CAD data
Dimension drawings, as well as 2D and 3D CAD data, can be generated in commonly used
formats using CAD CREATOR.
For further information, see the following Internet address
(http://support.automation.siemens.
com/WW/view/en/30559271).
Circuit-diagram macros
EPLAN circuit-diagram macros are available for SIMOTION D4x5. The macros are
supported when you create circuit diagrams.
The following address will take you to the macros
(http://support.automation.siemens.
com/WW/view/en/31622426).
To Next Page
Loading...
Need help?
General
