Siemens SINAMICS G120C User Manual

10.2.1.2 Manual downloading from the memory card with the BOP-2
Overview
If you have backed up the settings of several converters on the memory card, the settings
download must be started manually.
Precondition
The following requirements apply:
• The converter power supply has been switched on.
• The converter settings are not protected against copying.
Download with active know-how protection with copy protection (Page401)
Function description
Procedure
1. Insert the memory card into the converter.
2. Select the download.
2.2.
3. Set the number of your data backup. You can back up 99 di󹪜erent settings on the memory
card.
2.
4. Start the data transfer.
2.
5. Wait until the converter has transferred the settings from the memory card.
2.
6. Back up the settings so that they are protected against power failure.
2.2.
2.
2.
You have transferred the settings from the memory card to the converter.
❒
Corrective maintenance
10.2Downloading the converter settings
SINAMICS G120C Converters
Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK 383

Siemens SINAMICS G120C Specifications

General

Communication Interfaces	PROFINET, PROFIBUS, USS, Modbus RTU
Protection Class	IP20
Ambient Temperature	-10°C to +50°C
Storage Temperature	-40°C to +70°C
Power Range	0.55 kW to 132 kW
Voltage Range	380 V to 480 V
Output Voltage	0 V to Supply Voltage
Frequency Range	0 Hz to rated output frequency
Control Modes	Vector control with encoder
Protection	Overload, overvoltage, undervoltage, short circuit, ground fault
Relative Humidity	5% to 95%, non-condensing
Altitude	Up to 2000 m without derating