For DCR-ttC30:
NP-FP50 120 140
(supplied)
NP-FP70 255 295
NP-FPg0 455 525
* With LCD BACKL[GHT set to ON.
O Notes
• The power will not be supplied from the baltery pack
when lhe AC Adaptor is connected m the DC IN jack
of your camcorder, even if its power cord is
disconnected from the wall outlet.
• The recording mid playback time will be shorter
when you use your camcorder in low _emperature.
• The CHG (charge) lamp flashes during charging, or
fl_e baltery intbrmation will not be correctly
displayed in following conditions.
The battery pack is not attached correctly.
The battery pack is damaged.
The battery pack is fully discharged. (For Battery
inform_lion only)
Step3: Turningthe
poweron
You need to slide the POWER switch
repeatedly to select the desired power mode
to record or play.
When using this camcorder for the first time,
the [CLOCK SET] screen appears (p. 22).
LENS COVERswitch
I
POWER switch
G}
You can use the AC Adaptor as the power
source when you do not want the battery to
run out. While you are using the AC Adaptor,
the battery pack will not lose its charge even
when it is attached to your camcorder.
PRECAUTION
Even if your camcorder is turned olt; AC power
(house current) is still supplied to it while
connecled to the wall outlet via the AC Adaptor.
Set the LENS COVER switch to
OPEN.
While pressing the green button, slide
the POWER switch down.
The power turns on.
To enter the recording or playing mode,
slide the switch repeatedly until the
respective lamp for the desired power mode
lights up.
_ _pE
CAMERA
Connect your camcorder as shown in
"Charging the battery pack" (p. 16).
• CAMERA-TAPE mode: To record on a tape.
• CAMERA-MEMORY mode: To record on a
"Memory Stick Duo."
• PLAY?EDIT mode: To play or edit pictures on
a tape or "Memory Stick Duo."
-_continued
Getting started 19
To Next Page
Loading...
Need help?
General