FIGURE
AND
INDEX
NUMBERS
Items in this section are referenced
by
figure and index numbers to the illustrations
which
appear
on the pullout pages immediately
following
the Diagrar.is section
of
this
instruction
manual.
INDENTATION
SYSTEM
This mechanical parts list
is
indented to indicate item relationships. Following
1s
an
example
of
the indentation system
used
in the Description column.
Assembly and/
or
Component
Detail
Part
of Assembly and/or Component
mounting hardware
for
Detail
Part
Parts
of
Detail
Part
mounting hardware
for
Parts
of
Detail
Part
mounting hardware
for
Assembly and/or Component
Mounting
hardware
always
appears in the same indentation
as
the item it mounts,
while the
detail parts
are
indented to the right. Indented items are
part
of, and included
with, the next higher indentation.
Mounting hardware
must
be purchased separately, unless otherwise specified.
PARTS
,ORDERING
INFORMATION
Replacement parts are
available
from
or
through your local Tektronix, Inc. Field
Office
or
representative.
Changes to Tektronix instruments are sometimes made to accommodate improved
components
as
they become
available,
and to give you the benefit
of
the latest circuit
improvements
developed
in
our
engineering department. It
is
therefore important, when
ordering parts, to
include the
following
information in
your
order: Part number, instru-
ment type
or
number, serial
or
model number, and modification number
if
applicable.
If a
part
you have ordered has been replaced with a new
or
improved part, your
local Tektronix, Inc. Field
Office
or representative
will
contact you concerning
any
change
in
part
number.
Change information,
if
any,
is
located
at
the rear
of
this manual.
ABBREVIATIONS
AND
SYMBOLS
For an explanation
of
the abbreviations and symbols used in this section, please refer
to the
page
immediately preceding the Electrical Parts
List
in this instruction manual.
To Next Page
Loading...
Need help?
General
