AFG3000 Series Arbitrary/Function Generators Service Manual 6-7
Removal and Installation Procedures
This section describes how to remove and install the major mechanical and
electrical modules. It provides the following information:
Preparation
Read this section to prepare for module removal and installation.
List of Modules on page 6-7 describes where to locate a list of replaceable
modules.
See Figure 8-1 on page 8-7 for an overview of how the entire arbitrary/function
generator is assembled.
Read the Summary of Procedures on page 6-8 to understand which procedure
to use to access a given module. Then read Tools Req uired on page 6-8 for a
list of tools needed to remove and install modules in the arbitrary/function
generator.
Flip feet, on page 6-9 begins a series of procedures that describe the removal
and installation of modules.
If you are disassembling the arbitrary/function generator for cleaning, refer to
Inspection and Cleaning on page 6-2 for cleaning instructions.
Adjustment after Repair
After the removal and replacement of a module due to electrical failure, perform
the adjustment procedures. Refer to the Adjustment Procedures section.
List of Modules
The Replaceable Parts List section provides a list of all replaceable modules. Any
electrical or mechanical module, assembly, or part listed in the parts list is referred
to as a module.
WARNING. Only qualified personnel should perform service procedures. Before
doing this or any other procedure in this manual, read the General Safety Summary
and Service Safety Summary found at beginning of this manual.
Always disconnect the power cord before disassembling any portion of the
arbitrary/function generator.
To prevent damage to electrical components, read Preventing ESD on page 6-1.
To Next Page
Loading...
Need help?
General
