Removal and Installation Procedures
6-12 AFG3000 Series Arbitrary/Function Generators Service Manual
Top Cover
You will need a torque-limiting Torx T-15 screwdriver and a flat-blade screwdriver
for this procedure.
Removal. To remove the top cover, refer to Figure 6-5 and follow these steps:
1. Remove the nine screws attaching the top cover to the main chassis and the rear
sub-panel. Four screws are on the upper part of the top cover. Five screws are
on the rear panel side.
2. Using a flat-blade screwdriver, pull the top cover backward.
Figure 6-5: Top cover removal
Installation. To install, reverse this procedure.
Front Case
You will need a torque-limiting Torx T-15 screwdriver.
Removal. To remove the front case, refer to Figure 6-6 and follow these steps:
1. Remove the front-panel knob by firmly grasping the knob and pulling it away
from the front panel.
2. Remove the four tapping screws attaching the front case to the main chassis.
3. The front case and the rubber switch can be removed together.
To Next Page
Loading...
Need help?
General
