Performance Verification (MSO70000/C Series, DSA/DPO70000B/C Series, and DPO7000 Series)
Conventions
Throughout these procedures the following conventions apply:
Each test procedure uses the following general format:
Title of Test
Equipment Required
Prerequis
ites
Procedure
Each procedure consists of as many steps, substeps, and subparts as required
to do the test. Steps, substeps, and subparts are sequenced as follows:
1. First Step
a. First Substep
First Subpart
Second Subpart
b. Secon
dSubstep
2. Second Step
In steps and substeps, the lead-in statement in italics instructs you what to do,
while the instructions that follow tell you how to do it, as in the example
step
below:
Initialize t he instrument: Push the front-panel Default Setup button.
STOP.TheSTOP notation at the left is accompanied by information you must
read to do the procedure properly.
The term "toolbar" refers to a row of buttons at the top of the display. The
term "menu bar" refers to a row of menus at the top of the display. You can
s
witch between toolbar and menu bar operating modes by using the menu at
the top right of the toolbar or menu bar. (See Figure 3-1.)
Item numbers in the equipment required lists refer to the equipment. (See
Table 3-2 on page 3-19.)
3–2 MSO70000/C, DSA70000B/C, DPO7000B/C, DPO7000, MSO5000, DPO5000 Series
To Next Page
Loading...
Need help?
General
