Getting Started
TDS3000 Series User Manual
1–7
Convenience Features
Autoset. Use Autoset to quickly set up the vertical, horizontal, and
trigger controls for a usable display. See page 3–4.
Scope QuickMenu. Use the built-in Scope QuickMenu for simplified
oscilloscope operation. See page 1–28.
Single Sequence. One button sets the trigger parameters to the correct
settings for a single-shot acquisition (or single-sequence acquisition).
See page 3–3.
Floppy Disk. Use the built-in floppy disk to store and recall wave-
forms and setups, as well as upgrade the oscilloscope firmware and
install new features. See page 3–43.
Probe Support. Use the standard probes or choose an optional probe
for a specific application. See page D–1 for information and
limitations.
Multilingual User Interface. On-screen menus and messages are in
11 languages. See page 3–61.
Optional Features
Application Modules. Install Advanced Trigger, Extended Video,
Telecom Mask Test, or FFT application modules to add new test and
measurement features. See page C–2.
Communication Modules. Install a communication module to add
RS-232, GPIB, VGA, or Ethernet local area network (LAN) ports for
remote programmability, sending hardcopy to a LAN printer, or
displaying the oscilloscope screen on a monitor. See page 1–17.
Battery Power. Install a rechargeable battery pack so you can use the
oscilloscope without line power. See page 1–10.
To Next Page
Loading...
Need help?
General
