Getting Started
TDS3000 Series User Manual
1–9
Operating Positions
Use the handle and feet to place the oscilloscope in a convenient
operating position.
Connecting Power
To connect a power cord, do these steps:
1. Open the strain relief and slip it over the power cord.
2. Snap the strain relief into its hole in the rear panel of the
oscilloscope.
3. Connect the power cord to the power input connector.
You can operate the oscilloscope from a grounded mains supply with
line voltage between 90 V
AC
and 250 V
AC
and frequency between
47 Hz and 440 Hz. The oscilloscope is grounded through the power
cord. The line fuse is internal and is not user replaceable.
To Next Page
Loading...
Need help?
General
