Getting Started
1–24
TDS3000 Series User Manual
1. COARSE. Causes the general purpose knob and position knobs to
make adjustments more quickly.
2. SELECT. Toggles between the two cursors to select the active
cursor.
3. General purpose knob. Moves the cursors. Sets numerical
parameter values for some menu items. Push COARSE to make
adjustments quickly.
4. Vertical POSITION. Adjusts the vertical position of the selected
waveform. Push COARSE to make adjustments more quickly.
5. Horizontal POSITION. Adjusts the trigger point location relative
to the acquired waveforms. Push COARSE to make adjustments
quickly.
6. Trigger LEVEL. Adjusts the trigger level.
7. RUN/STOP. Stops and restarts acquisition.
8. SINGLE SEQ. Sets acquisition, display, and trigger parameters
for a single-shot (single-sequence) acquisition.
9. SET TO 50%. Sets the trigger level to the midpoint of the
waveform.
10. AUTOSET. Automatically sets the vertical, horizontal, and
trigger controls for a usable display.
11. FORCE TRIG. Forces an immediate trigger event.
12. WAVEFORM INTENSITY. Controls waveform intensity.
13. B TRIG. Activates the B trigger. Changes the trigger menu to set
the B-trigger parameters.
14. DELAY. Enables delayed acquisition relative to the trigger event.
Use horizontal POSITION to set the amount of delay.
To Next Page
Loading...
Need help?
General
